Services

Advisory

At Vivion Haus we accompany every stage of the project, combining high energy efficiency products with specialized technical advisory. Our goal: tailored, efficient, and sustainable solutions.

Advisory

We evaluate site conditions, comfort needs and technical possibilities to recommend the best solution.

We perform the calculation and sizing required for your project.

We prepare detailed comparative quotes for your review.

Pellet heaters

Installation

Smoke outlets

Smoke outlets 1
Smoke outlets 2

There are different possibilities to route the chimney to the outside. They all require a minimum height of 1.5 – 2 meters, making them very versatile as shown in the attached figures.

Combustion is almost perfect, producing virtually no smoke, so there is no need to install large chimneys. Ash formation is also minimal since the energy efficiency of these devices can be very high. The smoke outlet required by a pellet stove is very small in diameter (usually 80 mm), which makes its integration into the building very convenient and attractive.

For proper operation, it is essential to ensure air recycling in the room through an air intake.

When routing the chimney, keep in mind that an excess of elbows and horizontal sections can cause the heater to malfunction.

Electrical supply

Electrical supply

When deciding where to install the heater we must know that we will need a grounded electrical outlet. Pellet heaters require electricity to drive the fans, the feed screw and also for initial ignition.

This power consumption during operation can range from 100W-150W, reaching 400W at start-up.

Safety

Safety

The only risks that may arise from using the heater are those derived from an incorrect installation, direct contact with live electrical parts (interior), contact with fire and hot parts (glass, tubes, hot air outlet) or the introduction of unsuitable substances (only use pellets as fuel).

In the event of component failure, the heater is equipped with safety devices that ensure it shuts down without any external intervention.

Important information

Do not use flammable products to clean the smoke duct.
The glass can be cleaned with the appropriate product and a COLD cloth. Do not clean when hot.
During heater operation, the outlet pipes and door reach high temperatures.
Do not obstruct the ventilation openings in the installation room, nor the air intakes of the heater itself.
Before carrying out any maintenance, unplug the appliance from the electrical mains.
The firebox and hopper parts must only be vacuumed with a vacuum cleaner. Do not vacuum hot embers.
Make sure the heater is installed and commissioned by a qualified Technical Assistance Service, which will fill out the warranty, thus assuming responsibility for correct installation.
Do not place objects that are not heat-resistant near the heater.
Do not wet the heater, do not approach the electrical parts with wet hands.
To NOT compromise the operation of the heater, it is essential NOT to burn anything else or any type of fuel not recommended by the manufacturer in it.
REQUEST INSTALLATION

Maintenance

Request maintenance
Frequency Who
Do you need help?

Schedule your installation or
maintenance technical visit from our form